Functionality

Parameter		Value
Interface		CAN
Protocol		CANOPEN
Power supply		From the process supply voltage UP
Supply of the electronic circuitry of the decentralized communication interface modules attached		Through the expansion bus interface (I/O bus)
Rotary switches		For setting the CANOPEN Node ID for configuration purposes (00h to FFh)
LED displays		For system displays, signal states, errors and power supply
External supply voltage		Via terminals ZP, UP and UP3 (process supply voltage 24 VDC)
Transmission rates		10 / 20 / 50 / 125 / 250 / 500 / 800 kbit/s 1 Mbit/s Auto baudrate detection is supported
Bus connection		Depending on used terminal unit TU510: 9-pin D-sub connector TU518: 10-pin terminal block
Processor		Hilscher netX100
Expandability		Max. 10 S500 I/O modules
State display		Module state: PWR/RUN, CN-RUN, CN-ERR, E-ERR, I/O bus
Adjusting elements		2 rotary switches for generation of the node address
Ambient temperature		System data AC500 System Data AC500 System data AC500 XC System Data AC500-XC
Current consumption		UP: 0.2 A UP3: 0.06 A + 0.5 A max. per output
Weight (without terminal unit)		Ca. 125g
Process supply voltages UP/UP3
	Rated value	24 VDC (for inputs and outputs)
	Max. load for the terminals	10 A
	Protection against reversed voltage	Yes
	Rated protection fuse on UP/UP3	10 A fast
	Galvanic isolation	CANOPEN interface against the rest of the module
	Inrush current from UP (at power up)	On request
	Current consumption via UP (normal operation)	0.2 A
	Current consumption via UP3	0.06 A + 0.5 A max. per output
	Connections	Terminals 2.8 and 3.8 for +24 V (UP) Terminal 4.8 for +24 V (UP3) Terminals 2.9, 3.9 and 4.9 for 0 V (ZP)
Max. power dissipation within the module		6 W
Reference potential for all digital inputs and outputs		Minus pole of the supply voltage, signal name ZP
Setting of the CANOPEN Node ID identifier		With 2 rotary switches at the front side of the module
Mounting position		Horizontal Or vertical with derating (output load reduced to 50 % at 40 °C per group)
Cooling		The natural convection cooling must not be hindered by cable ducts or other parts in the switch-gear cabinet.
Effect of incorrect input terminal connection		Wrong or no signal detected, no damage up to 35V
Required terminal unit		TU509, TU510, TU517 or TU518 TU509 and TU510 for Communication Interface Modules TU517 and TU518 for Communication Interface Modules

Note

All I/O channels (digital and analog) are protected against reverse polarity, reverse supply, short circuit and continuous overvoltage up to 30 VDC.

CI582-CN: Input/Output Characteristics

Parameter	Value
Inputs and outputs	8 digital inputs (24 VDC) 8 digital transistor outputs (24 VDC, 0.5 A max.) 8 configurable digital inputs/outputs (24 VDC, 0.5 A max.)