Channel \ parameters for the analog outputs (2x)

Name	Value	Internal value	Internal value, type	Default
Output 0, Channel configuration	Table Operating modes of the analog outputs CI501-PNIO	Table Operating modes of the analog outputs CI501-PNIO	BYTE	0
Output 0, Check channel	Table Channel monitoring CI501-PNIO	Table Channel monitoring CI501-PNIO	BYTE	0
Output 0, Substitute value	Table Substitute value CI501-PNIO	Table Substitute value CI501-PNIO	WORD	0
Output 1, Channel configuration	Table Operating modes of the analog outputs CI501-PNIO	Table Operating modes of the analog outputs CI501-PNIO	BYTE	0
Output 1, Check channel	Table Channel monitoring CI501-PNIO	Table Channel monitoring CI501-PNIO	BYTE	0
Output 1, Substitute value	Table Substitute value CI501-PNIO	Table Substitute value CI501-PNIO	WORD	0

Channel configuration

Internal value	Operating modes of the analog outputs, individually configurable
0 (default)	Not used
128	-10 V…+10 V
129	0…20 mA
130	4…20 mA

Channel monitoring

Internal value	Check channel
0	Plausib(ility), Cut wire, Short circuit
3	None

Substitute value

Intended behaviour of output channel when the control system stops	Required setting of the module parameter “Behaviour of outputs in case of a communication error”	Required setting of the channel parameter “Substitute value”
Output OFF	Off	0
Last value infinite	Last value	0
Last value for 5 s and then turn off	Last value 5 sec	0
Last value for 10 s and then turn off	Last value 10 sec	0
Substitute value infinite	Substitute value	Depending on configuration
Substitute value for 5 s and then turn off	Substitute value 5 sec	Depending on configuration
Substitute value for 10 s and then turn off	Substitute value 10 sec	Depending on configuration