Parametrization¶
Arrangement of parameter data is performed by your master configuration software Automation_Builder.
Caution
:strong:Risk of configuration errors!
Contradictory parameter settings may cause configuration errors of the CI590-CS31-HA and attached I/O modules. Please make sure, the high-speed counter mode is not set to value 0 if the module is included with high-speed counters in PLC configuration.
The parameter data directly influences module functionality.
For non-standard applications, it is necessary to adapt the parameters to your system configuration.
| Name | Value | Internal Value | Internal Value, Type | Default | Min. | Max. |
|---|---|---|---|---|---|---|
| Module address | 1 | 2740 1) | BYTE | 2740 0 x 0AB4 |
0 | 61 |
| Ignore module | No Yes |
0 1 |
BYTE | No (0 x 00) | - | - |
| Parameter length | Internal | 8 7 2) |
BYTE | 8 7 2) |
0 | 255 |
| Check supply | Off On |
0 1 |
BYTE | On 0 x 01 |
- | - |
| Error LED / Failsafe Function | On Off by E4 Off by E3 On + Failsafe Off by E4 + Failsafe Off by E3 + Failsafe |
- | - | On | - | - |
| Stop behavior | Switch over Stop Both stop/failsafe |
0 1 2 |
BYTE | 0 | - | - |
| Output compare | No check Binary Analog ± 256 Analog ± 512 Binary + Analog 256 Binary + Analog 512 |
0 1 2 3 4 5 |
BYTE | 0 | - | - |
| Input delay | 0.1 ms 1 ms 8 ms 32 ms |
0 1 2 3 |
BYTE | 8 ms 0 x 02 |
- | - |
| Fast counter | 0 : 10 3) |
0 : 10 |
BYTE | Mode 0 0 x 00 |
- | - |
| Detection short-circuit at outputs | Off On |
0 1 |
BYTE | On 0 x 01 |
- | - |
| Behavior outputs at communication fault | Off Last value Substitute value |
0 1 2 |
BYTE | Off 0 x 00 |
- | - |
| Substitute value | 0…65535 | 0…0xffff | WORD | 0 | - | - |
1) with CS31 and addresses less than 70 and FBP, the value is increased by 1.
2) with CS31 and addresses less than 70, without the parameter “High-speed counter”.
3) Counter operating modes, see description of the high-speed counter.