Parameterization¶
| Firmware version | Configuration |
|---|---|
| Firmware version > V2.0.0 | The arrangement of the parameter data is performed by Control Builder Plus/ Automation_Builder software. |
The parameter data directly influences the functionality of modules.
For non-standard applications, it is necessary to adapt the parameters to your system configuration.
Module: Module slot address: Y = 1…10
| Name | Value | Internal value | Internal value, type | Default | Min. | Max. | EDS Slot/Index |
|---|---|---|---|---|---|---|---|
| Module ID | Internal | 1210 1) |
Word | 1210 0x04BA |
0 | 65535 | 0x0Y01 |
Ignore module 2) |
No Yes |
0 1 |
Byte | No 0x00 |
Not for FBP | ||
| Parameter length | Internal | 5 | Byte | 5-CPU 4-FBP |
0 | 255 | 0x0Y02 |
| Check supply | Off On |
0 1 |
Byte | On 0x01 |
0 | 1 | 0x0Y03 |
| Input delay | 0.1 ms 1 ms 8 ms 32 ms |
0 1 2 3 |
Byte | 8 ms 0x02 |
0 | 3 | 0x0Y04 |
Fast Counter 4) |
0 : 10 3) |
0 : 10 |
Byte | Mode 0 0x00 |
Not for FBP | ||
| Behaviour of outputs at communication errors | Off Last value Substitute value |
0 1+(n*5) 2+(n*5), n <= 2 |
Byte | Off 0x00 |
0 | 2 | 0x0Y05 |
Substitute value at outputs) Bit 7 = Output 7 Bit 0 = Output 0 |
0… 255 |
0… 0xff |
Byte | 0 0x00 |
0 | 255 | 0x0Y06 |
Remarks:
| 1) | With CS31 and addresses smaller than 70 and FBP, the value is increased by 1 |
| 2) | Not with FBP |
| 3) | For a description of the counter operating modes, please refer to the Fast Counter section Fast Counter |
| 4) | With FBP and without the parameter Fast Counter |
GSD file:
Ext_User_Prm_Data_Len = Ext_User_Prm_Data_Const
|
7 0x04, 0xbb, 0x04, \ 0x01, 0x02, 0x00, 0x00; |