Technical Data of the Digital \ Outputs

Parameter		Value
Number of channels per module		32 outputs (with transistors)
Distribution of the channels into groups		1 group of 32 channels
Connection of the channels
	O0 to O7	Terminals 1.0 to 1.7
	O8 to O15	Terminals 2.0 to 2.7
	O16 to O23	Terminals 3.0 to 3.7
	O24 to O31	Terminals 4.0 to 4.7
Indication of the output signals		1 yellow LED per channel, the LED is ON if the output signal is high (signal 1)
Reference potential for all outputs		Terminals 1.9, 2.9, 3.9 and 4.9 (negative pole of the process supply voltage, signal name ZP)
Common power supply voltage		For all outputs: terminals 1.8, 2.8, 3.8 and 4.8 (positive pole of the process supply voltage, signal name UP)
Output voltage for signal 1		UP (-0.8 V)
Output delay (0 -> 1 or 1 -> 0)		On request
Output data length		4 bytes
Output current
	Rated value, per channel	500 mA at UP = 24 V
	Maximum value (channels O0 to O15)	4 A
	Maximum value (channels O16 to O31)	4 A
	Maximum value (all channels together)	8 A
Max. leakage current with signal 0		< 0.5 mA
Rated protection fuse on UP		10 A fast
Demagnetization when inductive loads are switched off		With varistors integrated in the module (see figure below)
Switching frequency
	With resistive load	On request
	With inductive loads	Max. 0.5 Hz
	With lamp loads	Max. 11 Hz with max. 5 W
Short-circuit proof / overload proof		Yes
Overload message (I > 0.7 A)		Yes, after ca. 100 ms
Output current limitation		Yes, automatic reactivation after short-circuit/overload
Resistance to feedback against 24 V signals		Yes
Max. cable length
	Shielded	1000 m
	Unshielded	600 m

The following drawing shows the circuitry of a digital output with the varistors for demagnetization when inductive loads are switched off.