Setting COMx - CS31ΒΆ
- Right-click
- and select COMx_CS31 from the list.
The serial interface is definitely set as CS31 bus master. COM2 cannot be used as CS31 bus interface.
The following parameters are available:
| Parameter | Default value |
Value | Meaning |
|---|---|---|---|
| Run on config fault | No | No | The PLC program is executed even if there are faults in configuration. |
| Yes | The PLC program is not executed if there are faults in configuration. | ||
| Operating mode (read only) | Master | Master | Operating mode of the CS31 device. This parameter is read-only (not editable). |
| Max wait run | 0 | Max. wait time for valid inputs. | |
| Min update time | 10 | Cycle time for data exchange to IEC program. |
For further information on configuring CS31 Modules and I/O channels, see AC500 CS31 Bus Configuration of CS31 Bus Master.