DisplaysΒΆ
During the power on procedure, the module initializes automatically. All LEDs (except the LEDs for the signal statuses) are on during the initialization time.
| LED | Status | Color | LED = ON | LED = OFF | LED flashing |
|---|---|---|---|---|---|
| AI0 - AI15 | Analog channel status | Green | Channel activated and OK | Channel deactivated | CMS measurement running |
| Red | Short circuit (only in IEPE Mode) Over- / Undervoltage (only in +-10V Mode) | - | Cable break (only in IEPE mode) | ||
| A, B, Z | Encoder 0 inputs | Yellow | Input ON | Input OFF | LED follows the status of the inputs, depending on frequency |
| DI0, DI1, DC2, DC3 | Digital inputs | Yellow | Input = ON (the input voltage is even displayed if the supply voltage is OFF). | Input = OFF | - |
| DC2, DC3 | Digital outputs | Yellow | Output = ON | Output OFF | - |
| 5 V | Power supply for encoders | Green | Configuration ON and power 5-V-power ready | Configuration OFF or power failure | Power supply outputs are short-circuited |
| L+ | Process supply voltage | Green | Process voltage OK Initialization finished | Process voltage OFF | Firmware update |
| CH-ERR1, CH-ERR2 | Red | Serious error within the corresponding group | No error or process voltage is missing | Error on one channel of the corresponding group (e.g. short-circuit at an output) |