Parameterization

The arrangement of the parameter data is depending on the firmware version installed inside the CPUs and Bus Modules:

Firmware version	Mounting position	Configuration
Firmware version < V2.0.0	I/O Module connected locally to a CPU I/O Module connected to CS31 Bus Module	The arrangement of the parameter data is performed by PLC-Configuration inside Control Builder software.
	I/O Module connected remotely to a Bus Module (not CS31)	The arrangement of the parameter data is performed by your master configuration software SYCON.net in connection with the S500 GSD files and in conjunction with the Control Builder software.
Firmware version > V2.0.0	All	The arrangement of the parameter data is performed by Control Builder Plus software.

The parameter data directly influences the functionality of modules.

For non-standard applications, it is necessary to adapt the parameters to your system configuration.

Module: Module slot address: Y = 1…7

Nr.	Name	Value	Internal value	Internal value, type	Default	Min.	Max.	EDS Slot/Index
1	Module ID	Internal	1205 *1)	Word	1205 0x04B5	0	65535	0x0Y01
2 *2)	Ignore module	No Yes	0 1	Byte	No 0x00			not for FBP
3	Parameter length	Internal	4	Byte	4-CPU 4-FBP	0	255	0x0Y02
4	Check supply	Off on	0 1	Byte	On 0x01	0	1	0x0Y03
5	Input delay	20 ms 100 ms	0 1	Byte	20 ms 0x00	0	1	0x0Y04
6	Behaviour of outputs at communication errors	Off Last value Substitute value	0 1+(n*5) 2+(n*5), n <= 2	Byte	Off 0x00	0	2	0x0Y05
7	Substitute value at outputs Bit 3 = Output 3 Bit 0 = Output 0	0…15	0… 0x0f	Byte	0 0x00	0	15	0x0Y06

*1) With CS31 and addresses less than 70 and FBP, the value is increased by 1

*2) Not with FBP

GSD file:

Ext_User_Prm_Data_Len = Ext_User_Prm_Data_Const =

7 0x04, 0xb6, 0x04, \ 0x01, 0x00, 0x00, 0x00;