Connection of Wires at the Spring TerminalsΒΆ
Connect the wire to the spring terminal
Side view (open terminal drawn for illustration)
The top view shows the openings for wire and screwdriver
Insert screwdriver (2.5 x 0.4 to 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15 mm free of insulation at the tip
While erecting the screwdriver, insert it until the stop (requires a little strength)
Screwdriver inserted - terminal open
Strip the wire for 7 mm (and put on wire end ferrule)
Insert wire into the open terminal
Done
Disconnect wire from the spring terminal
Terminal with wire connected
Insert screwdriver (2.5 x 0.4 to 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15 mm free of insulation at the tip
While erecting the screwdriver, insert it until the stop (requires a little strength) - terminal is now open
Remove wire from the open terminal
Done