Insertion

Note

The TA541 lithium battery is the only applicable battery for Processor Modules PM595.

1. Remove the front cover / display by pressing the marked areas and pull it to the front.

2. Remove the old battery from the battery compartment by pulling it by the small cable. Remove then the small connector from the socket, do this best by lifting it out with a screwdriver.

3. Remove the battery from its package and hold it by the small cable.

4. Insert the battery connector into the small connector port of the compartment. The connector is keyed to find the correct polarity (red = plus-pole = right side).

5. Insert the battery into the battery compartment on the left side as shown in the picture.

6. Re-assemble the front cover / display by pressing it straight from the front until it snaps in.

Note

In order to prevent data losses or problems, the battery should be replaced after 3 years of utilisation or at least as soon as possible after receiving the “low battery warning” indication.

Do not use a battery older than 3 years for replacement, do not keep batteries too long in stock.