TK503 - Programming CableΒΆ
- PC-side: USB connector type A
- AC500-side: SUB-D, 9-pin, male
- Length 3 m
Intended Purpose
TK503 programming cable connects the USB interface of a PC with the serial interface of a Processor Module. It is used for programming purposes. TK503 can be used with all AC500 Processor Modules.
Note
With AC500/AC500-eCo Processor Modules, only the ABB programming cables TK50x can be used. Other cables may cause communication faults and must not be used.
Electrical Connection
Install the device driver for the programming cable.
Note
Once you have installed the device driver of the cable in your Windows system, make sure that you use always the same USB port of your computer. Otherwise, Windows will ask you to install the driver a second time if you connect the cable to a different USB port of your computer.
Plug the 9-pin Sub-D plug to the connector at the Processor Module and tighten it there.
Plug the USB connector to an USB interface at your PC.
Technical Data
The System Data of AC500 and S500 System Data AC500are valid here. Only additional details are therefore documented below.
| Connector at the PC (USB interface) | USB connector type A |
| Connector at the Processor Module | SUB-D, 9-pin, male |
| Length | 3 m |
| Cable type | On request |
| Weight | On request |
Ordering Data
| Ordering No. | Scope of delivery |
|---|---|
| 1TNE 968 901 R1100 | TK503, programming cable USB -> SUB-D (RS485), length 3 m |