TK504 - Programming CableΒΆ
- PC-side: USB connector type A
- AC500-side: 5-pole terminal block
- Length 3 m
Intended Purpose
TK504 programming cable connects the USB interface of a PC with the serial interface of Processor Module PM55x and PM56x. It is used for programming purposes.
Caution
:strong:Risk of communication faults!
The mechanical connection of TK504 may get lost due to mechanical vibration.
Use TK504 only for programming and debugging. A permanent usage is not foreseen.
Note
With AC500/AC500-eCo Processor Modules, only the ABB programming cables TK50x can be used. Other cables may cause communication faults and must not be used.
Electrical Connection
Install the device driver for the programming cable.
Note
Once you have installed the device driver of the cable in your Windows system, make sure that you use always the same USB port of your computer. Otherwise, Windows will ask you to install the driver a second time if you connect the cable to a different USB port of your computer.
Connect the 5-pole terminal block of the TK504 to the Processor Module Serial Interface COM2.
Plug the USB connector to an USB interface at your PC.
Technical Data
The System Data of AC500 and S500 System Data AC500are valid here. Only additional details are therefore documented below.
| Connector at the PC (USB interface) | USB connector type A |
| Connector at the Processor Module | Single conductors |
| Length | 3 m |
| Cable type | On request |
| Weight | On request |
Ordering Data
| Ordering No. | Scope of delivery |
|---|---|
| 1TNE 968 901 R2100 | TK504, programming cable USB -> single conductors, length 3 m |