Input Description¶
EN
| Data_Type | Default_Value | Range | Unit |
|---|---|---|---|
| BOOL | - | - | - |
If EN = TRUE, the Function Block checks the input values. If they are valid, the Function Block reads the receiving buffer of the corresponding COMx interface one-time.
EN = TRUE - Reading of the receiving buffer
EN = FALSE - No reading of the receiving buffer
COM
| Data_Type | Default_Value | Range | Unit |
|---|---|---|---|
| BYTE | - | - | - |
At the COM input, the number of the serial interface is specified.
COM = 1: COM1
COM = 2: COM2
DATA
| Data_Type | Default_Value | Range | Unit |
|---|---|---|---|
| DWORD | - | - | - |
At input DATA, the start address for storing the received data is specified using an ADR operator. Received data can be stored in the operand area as well as in variables. Some peculiarities have to be observed when receiving binary values.
When using IEC bit operands as storage address, only operands are allowed which end with “.0” (e.g. %QX62.0 allowed, %QX62.1 forbidden).
When storing a received telegram within the IEC bit operand area, it has to be observed that a received byte describes 8 bit operands. However, if a received telegram is stored to a Boolean variable, this variable is considered as FALSE if the byte has the value 0 and TRUE for all other values of the byte.
LEN
| Data_Type | Default_Value | Range | Unit |
|---|---|---|---|
| WORD | - | - | - |
LEN outputs the length of the received data (in bytes) including end character (if contained). LEN is only valid if DONE = TRUE. LEN has always to be considered together with output ERR.
END_LEN
| Data_Type | Default_Value | Range | Unit |
|---|---|---|---|
| BYTE | - | - | - |
Number of end characters to be attached: 0, 1, 2 means none, one or two.
The input´s LEN and END_LEN have to be smaller than 256! If not an error appears!
END_CH
| Data_Type | Default_Value | Range | Unit |
|---|---|---|---|
| WORD | - | - | - |
At input END_CH, the value of the telegram end character(s) must be specified which has (have) to be attached to the actual transmit data. END_CH is considered if input END_LEN of the COM_SEND Function Block is not 0. END_CH is applied with a FALSE > TRUE edge at EN. If required, the end character can vary within each telegram.
If, for example, a CR/LF shall be attached to a telegram, the value of END_CH is as follows: 16#0D0A and END_LEN: 2.