Error Messages, Warnings and Notes (Dialogs)

Wrong Target

../_images/f95eccc246009fba0a33139000eba54e1

This error message appears if there is a mismatch between the selected target in Automation_Builder and the CPU hardware. For example, the selected CPU type is PM583-ETH and in Automation_Builder project, the configured CPU type is PM573-ETH.

A login to the CPU is not possible.

To avoid this error message, correct the project to the appropriate CPU target.

Configuration not yet in PLC

Note

The following warning message will only appear with CPU firmware V2.3.0 or higher.

../_images/601087e246009db80a33139000eba54e1

This warning message appears if the current project in Automation_Builder and the project located inside the PLC are different.

../_images/4b8fdfa346009cdd0a33139000eba54e1

To avoid this warning message, perform the following tasks:

  • Log out from the PLC.
  • Re-create configuration data (right-click on AC500_Product_Name ‣ Check configuration).
  • Download the IEC application program to the PLC via IEC 61131-3 editor V2.3.x (a full download is needed).
  • Log in for Online Diagnosis again.

Old Profile in Firmware

Note

The following warning message will only appear with CPU firmware V2.3.0 or higher.

../_images/d5f4d91846009f0f0a33139000eba54e2

This warning messages appears, if the firmware version inside the PLC is older than the version profile of Automation_Builder and therefore, the CPU’s firmware does not support all features of the current version profile of Automation_Builder.

../_images/b6f892b34600a0280a33139000eba54e1

To avoid this warning message, perform one of the following tasks:

  • Update the CPU’s firmware to the version which is equivalent to the Automation_Builder version profile.
  • Select a version profile in Automation_Builder which is equivalent to the firmware version of the CPU.