TK503 - Programming Cable

• PC-side: USB connector type A
• AC500-side: SUB-D, 9-pin, male
• Length 3 m

Intended Purpose

TK503 programming cable connects the USB interface of a PC with the serial interface of a Processor Module. It is used for programming purposes. TK503 can be used with all AC500 Processor Modules.

Note

With AC500/AC500-eCo Processor Modules, only the ABB programming cables TK50x can be used. Other cables may cause communication faults and must not be used.

Electrical Connection

1. Install the device driver for the programming cable (see TK503 - Programming Cable).

   Note

   Once you have installed the device driver of the cable in your Windows system, make sure that you use always the same USB port of your computer. Otherwise, Windows will ask you to install the driver a second time if you connect the cable to a different USB port of your computer.

2. Plug the 9-pin Sub-D plug to the connector at the Processor Module and tighten it there.

3. Plug the USB connector to an USB interface at your PC.

Technical Data

Connector at the PC (USB interface)	USB connector type A
Connector at the Processor Module	SUB-D, 9-pin, male
Length	3 m
Cable type	Programming cable
Weight	0.4 kg

Ordering Data

Order No.	Scope of delivery	Product life cycle status
1TNE 968 901 R1100	TK503, programming cable USB -> SUB-D (RS485), length 3 m	Active

Note

*) For planning and commissioning of new installations use modules in Active status only.

Installation of cable driver