TK504 - Programming Cable

• PC-side: USB connector type A
• AC500-side: 5-pole terminal block
• Length 3 m

Intended Purpose

TK504 programming cable connects the USB interface of a PC with the serial interface of Processor Module PM55x and PM56x. It is used for programming purposes.

Caution

:strong:Risk of communication faults!

The mechanical connection of TK504 may get lost due to mechanical vibration.

Use TK504 only for programming and debugging. A permanent usage is not foreseen.

Note

With AC500/AC500-eCo Processor Modules, only the ABB programming cables TK50x can be used. Other cables may cause communication faults and must not be used.

Electrical Connection

1. Install the device driver for the programming cable (see TK504 - Programming Cable).

   Note

   Once you have installed the device driver of the cable in your Windows system, make sure that you use always the same USB port of your computer. Otherwise, Windows will ask you to install the driver a second time if you connect the cable to a different USB port of your computer.

2. Connect the 5-pole terminal block of the TK504 to the Processor Module Serial Interface COM2.

3. Plug the USB connector to an USB interface at your PC.

Technical Data

Connector at the PC (USB interface)	USB connector type A
Connector at the Processor Module	Single conductors
Length	3 m
Cable type	Programming cable
Weight	0.4 kg

Ordering Data

Order No.	Scope of delivery	Product life cycle status
1TNE 968 901 R2100	TK504, programming cable USB -> single conductors, length 3 m	Active

Note

*) For planning and commissioning of new installations use modules in Active status only.

Installation of cable driver