Configuration of the External Communication \ Module CM597-ETH (Extended Settings)ΒΆ
The following parameters are available:
| Parameter | Default | Value | Description |
|---|---|---|---|
| Remote configuration | |||
| ABB NetConfig protocol active | Enabled | Disabled | ABB NetConfig protocol is disabled. IP Config Tool is not supported in this case. |
| Enabled | ABBNetConfig protocol is enabled. IP Config Tool can be used to configure the device. | ||
| Hilscher NetIdent protocol active | Enabled | Disabled | The Hilscher NetIdent protocol is disabled. Hilscher IP Config Tool is not supported in this case. |
| Enabled | The Hilscher NetIdent protocol is enabled. Hilscher IP Config Tool can be used to configure the IP of the device temporarily. | ||
Note
ABB NetConfig protocol is more secure than Hilscher NetIdent protocol. It is recommended to disable the Hilscher NetIdent protocol if not needed.