Configuration of the External Communication Module CM597-ETH (IP Data)¶
Note
The IP data are used with highest priority. Existing settings done by the display or any other method will be overwritten.
Double-click the IP_Settings node to open the IP settings in the editor window:
The following parameters are available:
| Parameter | Default | Value | Description | Parameter (Remark 1 Configuration of the External Communication Module CM597-ETH (IP Data)) |
|---|---|---|---|---|
| Force IP settings | Enabled | Disabled | The IP data is not used. The device must be configured by another means of settings the IP data. | Use IP data |
| Enabled | The IP data set in this editor is used for the device. | |||
| DHCP | Disabled | Disabled | The DHCP client services are disabled. A static IP address must be used. | IP mode (+ DHCP) |
| Enabled | The DHCP client services are enabled. The IP address of the device will be set by a DHCP server in the network. | |||
| IP address | 0.0.0.0 | Valid IP address | IP address of the device. | IP address |
| Subnetmask | 255.255.255.0 | Valid subnet mask | Subnet mask for the device. | Netmask |
| Default gateway | 0.0.0.0 | Valid gateway address | Default gateway address for the device. | Gateway |
| Link mode | Auto negotiation | Auto negotiation | The link mode will be detected automatically. | Link mode |
| 10 Mbit Half-Duplex | The link mode is statically set to 10 Mbit half-duplex. | |||
| 10 Mbit Full-Duplex | The link mode is statically set to 10 Mbit full-duplex. | |||
| 100 Mbit Half-Duplex | The link mode is statically set to 100 Mbit half-duplex. | |||
| 100 Mbit Full-Duplex | The link mode is statically set to 100 Mbit full-duplex. |
Remark 1: Generic Device Configuration View Parameters
Tab IP Settings Configuration shows a list of all available parameters which is only visible if parameter ‘Show generic device configuration views’ is activated (in the menu click ).