Parameterization of the CM582-DP/CM592-DP Communication Module

To append a Communication Module, add the Communication Module to the Extension_Bus node.

• Right-click the desired Slot and select Add object.
• Select the Communication Module from the list and click Replace object.
• Double-click the new node to open the CM582/CM592 - PROFIBUS DP (Interface) configuration in the editor window.

The following parameters are available:

Parameter	Default value	Value	Description
Run on config fault	No	No	In case of a configuration error, the user program is not started.
		Yes	The user program is started independent of a faulty configuration of the PROFIBUS Communication Module.
Min update time	10	0…20000	Minimum update time of inputs and outputs in [ms].