Firmware Update internal coupler of PM595 for ETHERCAT

To update the internal coupler to actual ETHERCAT Firmware proceed as follows:

1. Unzip the file „Update_ETHCAT.zip“ on SD card.

2. Insert the SD card into the PM595 CPU.

3. Switch Power Off/On.

   ⇒

   Run LED blinks oRun and Rdy LEDs on the left side of the PM595 (left column) for 1st. Internal coupler blink

   RUN LED blinks

   Run and Rdy LED on the left side of the PM595 (right column) for 2nd. Internal coupler blink

   RUN LED blinks slowly

   Note

   The procedure should require 3 – 5 minutes.

4. Remove the SD card.

5. Switch Power Off/On.

6. Login in Automation_Builder:

   Navigate to Version Informations.

   ⇒

   Firmware V 4.2.23 (2) or newer for Internal coupler must be displayed.