1000hex…1FFFhex - Device Error

DEC	HEX	Error description
4097	1001	Device does not exist
4098	1002	Command not supported by the device. The function is not supported by the device firmware/hardware. Block library newer than the device firmware. FC..: No high-speed counter available at the given module.
4100	1004	Error operating mode. FC..: Operating mode “0” -> No counter set in the PLC configuration.
4101	1005	Invalid status FLASH_READ: Block is not written yet FLASH_WRITE: Block was already written RETAIN..: No program loaded Library PROFINET IO: PNIO_WRITE, PNIO_READ: Internal error. Restart the PLC.
4117	1015	Format error SD..: File cannot be read because of an invalid format. Data could not be read or not be read completely.
4119	1017	Incorrect length PERSISTENT..: Data have an incorrect length RETAIN..: Data have an incorrect length
4120	1018	Checksum error
4122	101A	FC..: Internal error (e.g. no CS31 Adr parameter found, wrong size of CS31 Adr) HA..: Internal error (e.g. null pointer received, wrong return value of internal function, no entry in configuration found)
4123	101B	Device access error Flash..: Resources are not available HA..: Remote CPU failure: Other CPU is off or out of order PERSISTENT..: Data could not be copied, access error or no data do exist RETAIN..: Data could not be copied, access error or no data do exist SD..: Access to the SD card is not possible (e.g. memory exhausted, file already opened, etc.
4124	101C	Incorrect number PERSISTENT..: Because of the current CPU parameters, data are loaded only partly
4127	101F	Access protection SD..: SD card is write protected
4128	1020	Error when opening SD..: Error when opening a file stored on the SD card
4129	1021	Not found FC..: CS31 Bus Module not found ETHERCAT Modul not found HA_CS31_CONTROL: Own CI590-CS31-HA slave failure (missing module) HA_CS31_DIAG: One or more CI590-CS31-HA slave(s) is/are inactive HA_CS31_DIAG_VIA_CM574-RS: One or more CI590 are inactive SD..: The searched sector could not be found in the file TASK_INFO: Unknown task
4130	1022	End reached SD..: Section end or end of file reached PERSISTENT..: Because of the current CPU parameters, data are not loaded
4131	1023	Reading error FLASH..: Reading error in data segment: Incorrect checksum
4132	1024	Writing error FLASH..: Block cannot be programmed SD..: File could not be deleted or written
4137	1029	FC..: Wrong configuration (e.g. no CM574-RS configured on specified slot) HA..: Remote CI590-CS31-HA slave failure (missing module)
8191	1FFF	Not ready Flash..: The command is already executed by an other instance SD..: Command cannot be executed. Another instance is already active.