Connection of Wires at the Spring TerminalsΒΆ
Connection
Side view (open terminal drawn for illustration)
The top view shows the openings for wire and screwdriver
Insert screwdriver (2.5 x 0.4 to 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15 mm free of insulation at the tip
While erecting the screwdriver, insert it until the stop (requires a little strength)
Screwdriver inserted - terminal open
Strip the wire for 7 mm (and put on wire end ferrule)
Insert wire into the open terminal
Done
Disconnection
Terminal with wire connected
Insert screwdriver (2.5 x 0.4 to 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15 mm free of insulation at the tip
While erecting the screwdriver, insert it until the stop (requires a little strength) - terminal is now open
Remove wire from the open terminal
Done