Connection and Wiring

For detailed information such as technical data of your mounted devices (AC500 product family) refer to the hardware device description of the appropriate device.

Attention

:strong:Attention:

The devices should be installed by trained persons with knowledge of wiring electronic devices. In case of bad wiring, the following problems could occur:

• On the Terminal Base, the terminals L+ and M are doubled. If the power supply is badly connected, a short circuit could happen and lead to a destruction of the power supply or its fuse. If no suitable fuse exists, the Terminal Base itself could be destroyed.
• The Terminal Bases and all electronic modules and Terminal Units are protected against reverse polarity.
• All necessary measures should be carried out to avoid damages to modules and wiring. Notice the wiring plans and connection examples.

Attention

:strong:Attention:

All I/O channels (digital and analog) are protected against reverse polarity, reverse supply, short circuit and continuous overvoltage up to 30 VDC.

Attention

:strong:Attention:

Due to possible loss of communcation, the communication cables should be fixed with cable duct or bracket or clamp during application.

• Power Supply
  • Power Supply for Processor Modules
• Terminals for Power Supply and the COM1 Interface
• Terminals at the Terminal Unit
• Connection of Wires at the Spring Terminals
• Terminals for CANOPEN/DEVICENET Communication Modules
• Serial Interface COM1 of the Terminal Bases
• Serial Interface COM2 of the Terminal Bases
• CS31 system bus
  • Connection of the Processor Module to the CS31 system bus
  • Wiring
  • Bus Topology
  • Earthing
• CANOPEN Field Bus
• ETHERNET Connection Details
  • ETHERNET Interface
  • Wiring
  • Cable Types
• PROFIBUS Connection Details
• MODBUS RTU Connection Details