Channel \ Parameters for the Analog Outputs (2x)¶
| Name | Value | Internal value | Internal value, type | Default |
|---|---|---|---|---|
| Output 0, Channel configuration | Operation modes of analog outputs | Operation modes of analog outputs | BYTE | 0 |
| Output 0, Check channel | Channel monitoring | Channel monitoring | BYTE | 0 |
| Output 0, Substitute value | Substitute value | Substitute value | WORD | 0 |
| Output 1, Channel configuration | Operation modes of analog outputs | Operation modes of analog outputs | BYTE | 0 |
| Output 1, Check channel | Channel monitoring | Channel monitoring | BYTE | 0 |
| Output 1, Substitute value | Substitute value | Substitute value | WORD | 0 |
| Internal value | Operating Modes (individually configurable) |
|---|---|
| 0 (default) | Not used |
| 128 | -10 V…+10 V |
| 129 | 0…20 mA |
| 130 | 4…20 mA |
| Internal value | Check channel |
|---|---|
| 0 | Plausib(ility), cut wire, short circuit |
| 3 | None |
| Intended Behavior of Output Channel when the Control System Stops | Required Setting of the Module Parameter “Behavior of Outputs in Case of a Communication Error” | Required Setting of the Channel Parameter “Substitute value” |
|---|---|---|
| Output OFF | Off | 0 |
| Last value infinite | Last value | 0 |
| Last value for 5 s and then turn off | Last value 5 sec | 0 |
| Last value for 10 s and then turn off | Last value 10 sec | 0 |
| Substitute value infinite | Substitute value | Depending on configuration |
| Substitute value for 5 s and then turn off | Substitute value 5 sec | Depending on configuration |
| Substitute value for 10 s and then turn off | Substitute value 10 sec | Depending on configuration |