Programming the CM574-RS via the AC500 CPU (Routing)

For programming via the CPU, the following programming interfaces are available:

• Serial driver “ABB RS232 Route AC”
• ETHERNET driver (TCP/IP) “ABB Tcp/Ip Level2 AC”
• ARCNET driver “ABB ARCNET AC”

Setting up a gateway channel is described in the section Configuration in Automation Builder for AC500 V2 Products: Programming and Testing

This chapter only describes the settings for the routing to the CM574-RS.

• Programming via CPU with Serial Driver “ABB \ RS232 Route AC”
• Programming via CPU with ETHERNET Driver “ABB Tcp/Ip Level2 AC”
• Programming via CPU with ARCNET Driver “ABB ARCNET AC”