MC_WriteParameterΒΆ
Function Block MC_WriteParameter
When a drive based axis implementation is used, the Function Block writes the value of a drive specific parameter or a PLCopen parameter. When the Central Motion Control axis implementation is used, a parameter according to the list PLCopen parameter is written. PLCopen
Note
All available parameters are listed in this table: PLCopen
Note
See also:
- MC_ReadParameter to read parameters MC_ReadParameter
- MC_ReadBoolParameter to read boolean parameters MC_ReadParameter
- MC_WriteBoolParameter to write boolean parameters MC_WriteBoolParameter
See the following chapter to check if this Function Block is supported by the used axis implementation: Overview
For this Function Block there is a visualization in the Library MC_Blocks_AC500_V11.
See the following chapter for a list of available data types: Overview