MC_WriteBoolParameter

Function Block MC_WriteBoolParameter

When a drive based axis implementation is used, the Function Block writes the value of a drive specific BOOL parameter or a PLCopen BOOL parameter. When the Central Motion Control axis implementation is used, a BOOL parameter according to the list PLCopen parameter is written. PLCopen

Note

All available parameters are listed in this table: PLCopen

Note

See also:

• MC_ReadParameter to read parameters MC_ReadParameter
• MC_WriteParameter to write parameters MC_WriteParameter
• MC_ReadBoolParameter to read boolean parameters MC_ReadParameter

See the following chapter to check if this Function Block is supported by the used axis implementation: Overview

For this Function Block there is a visualization in the Library MC_Blocks_AC500_V11.

See the following chapter for a list of available data types: Overview

• Input Description
• Output Description