Connection of sensors to the 5-V-power-supply

The following figure shows the electrical connection of sensors to the 5-V-power-supply 0 of the module CD522. Proceed with the 5-V-power-supply 1 in the same way.

Note

Each 5-V-power supply provides a current of 100 mA max. It is possible to parallel both integrated power supply. In this case, the max. current is 200 mA.

Connection of sensors to the 5-V-power supply of the module CD522

Attention

:strong:Risk of damaging the CD522!

The integrated 2-A-fuse cannot be replaced. If it blows, the module must be replaced.

Ensure that the current per 0-V-connection does not exceed 0.5 A.

Attention

:strong:Risk of damaging the CD522!

The two 5-V-outputs have no protection against reverse polarity.

The meaning of the LEDs is described in the Displays Encoder & PWM Module CD522.

• Technical data of the digital inputs/outputs if used as standard inputs
• Technical data of the digital inputs/outputs if \ used as standard outputs
• Technical data of the high-speed inputs (A0, B0, \ Z0; A1, B1, Z1)
• Technical data of the fast outputs O0 and O1
• Technical data of the fast outputs (SSI CLK output \ B0, \ B1 \ for optical interface)
• Technical data of the fast outputs (SSI CLK output differential)
• Technical data of the 5-V-sensor-supply
• Technical data of the 0-V-reference-input