Connection and Wiring¶
For detailed information such as technical data of your mounted devices (AC500 product family) refer to the hardware device description of the appropriate device AC500 Device Description (Hardware).
Attention
:strong:Attention:
The devices should be installed by trained persons with knowledge of wiring electronic devices. In case of bad wiring, the following problems could occur:
- On the Terminal Base, the terminals L+ and M are doubled. If the power supply is badly connected, a short circuit could happen and lead to a destruction of the power supply or its fuse. If no suitable fuse exists, the Terminal Base itself could be destroyed.
- The Terminal Bases and all electronic modules and Terminal Units are protected against reverse polarity.
- All necessary measures should be carried out to avoid damages to modules and wiring. Notice the wiring plans and connection examples.
Attention
:strong:Attention:
All I/O channels (digital and analog) are protected against reverse polarity, reverse supply, short circuit and continuous overvoltage up to 30 V DC.
- Power Supply
- Terminals for Power Supply and the COM1 Interface
- Terminals at the Terminal Unit
- Connection of Wires at the Spring Terminals
- Terminals for CANopen Communication Modules
- Serial interface COM1 of the Terminal Bases (PM57x, PM58x, PM59x)
- Serial Interface COM2 of the Terminal Bases (PM57x, PM58x and PM59x)
- CS31 system bus (PM57x, PM58x, PM59x)
- Ethernet
- PROFIBUS®
- PROFINET®
- Modbus®RTU