AC500 PLC Configuration

Note

This chapter describes the AC500 Control System Configuration up to release V1.3.2 of the Control Builder software. From release V2.0.0, the configuration is done with ABB Control Builder Plus software. The procedure from V2.0.0 is described in detail in the documentation of the Control Builder Plus software.

• Overview on the PLC Configuration
  • PLC Configuration Functions
  • Export and Import of Configuration Data
  • Default Settings in the PLC Configuration \ for PM57x, PM58x and PM59x
  • Default Settings in the PLC Configuration \ for PM55x and PM56x
  • Setting Parameters in the PLC Configuration
• Configuration of CPU Parameters
  • CPU Parameters in PS501 Versions V1.0 and V1.1
  • CPU Parameters in Version PS501 V1.2
• I/O Bus Configuration
  • Setting the General I/O Bus Parameters
  • Inserting Input and Output Modules
  • Configuring the Input and Output Modules and \ Channels
  • Module Parameter “Ignore module” \ of S500 I/O Devices
• Configuration of the Serial Interfaces (Interfaces \ / COM1 and COM2)
  • Setting the Protocol of the Serial Interfaces
  • The Setting ‘COMx - Online access’
  • The Setting ‘COMx - ASCII’
  • The Setting ‘COMx - Modbus’
  • The Setting ‘COM1 - CS31 Bus’
  • The Setting ‘COMx - SysLibCom’
  • The Setting ‘COMx - Multi’
• FBP Slave Interface Configuration (Interfaces / \ FBP Slave)
• Communication Module Configuration (Communication \ Modules)
  • Configuring the Internal Communication Module
  • Configuring the External \ Communication Modules
• Configuration of Onboard I/O
  • Setting Standard Configuration
  • Configuring the Onboard I/O for CPU PM55x
  • Configuring the Onboard I/O for CPU PM56x